- 1). Remove the cabinet door. Locate the center jambs, or inside "walls," of the cabinet. There will be one on both sides of the opening. Measure the distance from the jambs to the inside of the face frame opening. It should be approximately 1 1/2 inches.
- 2). Measuring from the inside bottom of the cabinet face frame opening, screw the plywood shims one at a time to the right and left jambs centered at 3, 9, 15 and 21 inches from the bottom of the face frame opening running horizontally to the back. Screw one on then screw another one on top of that one bringing the shims flush to the inside edge of the cabinet face frame opening; these are your drawer runner side mounts.
- 3). Open the drawer guide package and separate the runners. Pick out the ones that say DL. Center and screw them on flush with the front of all four drawers on the left side. Screw the ones marked DR to the other side of the drawer. Use the screws that come in the package.
- 4). Center and screw on the runners marked CL ( left) and CR (right) to the plywood shims that you just installed, flushing them with the inside edge of the cabinet face frame.
- 5). Center and screw the oak lumber drawer front to the drawer from the inside of the drawer. You should have equal spacing all the way around the drawer front. Align the back of the drawer runner with the cabinet side runner. When the bearings fit into the slots on the runners of the cabinet and drawer, slide the drawer into the cabinet. Do all four drawers.
- Advertisement -
- Advertisement -