- 1). Locate an existing clump of Napier grass that is at least 6 to 8 inches in diameter. Cut off the green blades as close to the ground as possible using pruning shears or hand pruners.
- 2). Insert a shovel at the edge of the growth and insert it all the way into the soil so that it is 6 to 8 inches deep. Lean back on the handle of the shovel to lift the Napier grass roots out of the soil.
- 3). Pull the root clump out of the ground and brush away the excess soil with your hands. Separate out each individual grass shoot with your fingers and lay them flat on a tarp or towel so that you do not lose them in the surrounding grass.
- 4). Pick up one shoot and place it against a ruler. Measure down 2 inches along the root and cut the root off at this location using hand pruners. Repeat the process to prune the remaining roots.
- 5). Walk around the planting site and look for a location that has moist but not soggy soil and either full or partial sunlight.
- 6). Dig a hole that is approximately 3 inches wide by 3 inches deep, using a hand spade. Fill the bottom of the hole with approximately 1 to 2 inches of compost or manure.
- 7). Insert one Napier grass shoot into the hole making sure that the short green upper section stays above the ground. Fill in the hole with soil and pack it down firmly with your hands.
- 8). Continue using this method to plant all remaining Napier grass shoots and then water the area thoroughly until the soil is completely moist.
- Advertisement -
- Advertisement -