- 1). Measure around the planting pot (the one with the holes) just below the lip of the pot. Make a note of this measurement. Then, measure the diameter of the pot opening. Make a note of this measurement, as well.
- 2). Saw a hole in the table that is the same size as your first measurement. Take care to keep the hole smaller than the diameter of the pot opening, or the pot will fall through the hole. Err on the small side. The pot needs to rest in the hole without falling through.
- 3). Place the planting pot in the hole in the table. Fill planting pot to within an inch or two of the top with the chosen filler.
- 4). Place the two gallon bucket under the planting pot. This pot will catch the water from the planting pot.
- 5). Attach one piece of tubing to the intake valve on the water pump and the second piece of tubing to the outgoing valve on the air pump.
- 6). Place the water pump on the floor, next to the reservoir bucket. Place the free end of the intake tubing in the reservoir bucket. Be sure the tubing rests toward the bottom of the bucket. Use the clothespin to attach the tubing to the bucket. Be careful not to pinch the tube closed.
- 7). Place the free end of the outgoing tubing over the edge of the planting bucket. Use the clothespin to secure the tubing. Be careful not to pinch the tubing.
- 8). Plug the water pump into the timer and plug the timer into the wall outlet.
- 9). Fill reservoir bucket halfway with water, and turn the pump on. After one to three minutes, depending on the pump, water should flow through from the reservoir bucket, through the tubing and into the planting bucket.
- 10
Turn off the water pump. - 11
Place the stevia plant in the planting bucket. Be sure the roots are well covered by the chosen filler material. - 12
Add liquid nutrients to reservoir bucket. Follow package directions. - 13
Turn water pump back on, and enjoy the stevia.
- Advertisement -
- Advertisement -